The Hitachi HUA722050CLA330 500GB is a 3.5" 500GB Hard Disk Drive.
It uses the SATA 3Gb/s interface and has a speed of 7200 RPM.
|Hard Disk Drive
|This defines whether the drive is a large-capacity slower hard disk drive, a smaller-capacity but much faster solid-state drive, or a hybrid
|The size of the drive dictates which drive bays it will fit into - generally a small drive will fit into any bigger drive bay with an adapter
|The drive storage capacity is the limit to the size of files that can be stored
|01 Jan 2013
|The later the release, the more likely manufacturer support will still be around
|The bigger the cache, the more data that can be temporarily stored for faster access
|HDDs should generally require very little power to run, and SSDs even less
|The higher the RPM, the faster the hard drive, and the faster stored data can be accessed
|The interface is the type of motherboard connection and defines the bandwidth limit of the drive
The Hitachi HUA722050CLA330 500GB is a hard disk drive, which means it stores data using quickly rotating disks, or platters, that can be read and written on via the moving actuator arm. Hard disk drives generally have a large storage capacity, and so are perfect for large amounts of data. The potential performance is well below that of solid-state drives, but they can definitely still hold their own. The Hitachi HUA722050CLA330 500GB is a decent primary hard disk drive choice, but its performance is somewhat lacking.
With a cache of 32MB, the Hitachi HUA722050CLA330 500GB can store a large amount of data temporarily, which will result in speedy loading times for previously loaded files and applications. At a speed of 7200 RPM, the hard disk drive spins at about the market average for desktop PCs. This speed is widely considered the desktop standard, providing a good balance between reliability, cost, performance, and noise.
With a capacity of 500GB, the Hitachi HUA722050CLA330 500GB has a fairly small amount of storage for an hard disk drive. Using the SATA 2.0 3Gb/s interface this hard disk drive will not be limited by its connection with the motherboard, and there is currently no real reason to choose SATA 3.0 over SATA 2.0 for a mechanical hard disk drive (SSDs are another matter).
A form factor size of 3.5" is standard for desktop drives, and this will fit into any standard case drive bay, or into a 5.25" drive bay with an adapter.