The Hitachi HTS545032B9A300 300GB is a 2.5" 300GB Hard Disk Drive.
It uses the SATA 3Gb/s interface and has a speed of 5400 RPM.
|Drive Type||Hard Disk Drive||This defines whether the drive is a large-capacity slower hard disk drive, a smaller-capacity but much faster solid-state drive, or a hybrid|
|Physical Size||2.5"||The size of the drive dictates which drive bays it will fit into - generally a small drive will fit into any bigger drive bay with an adapter|
|Capacity||300GB||The drive storage capacity is the limit to the size of files that can be stored|
|Release Date||01 Apr 2009||The later the release, the more likely manufacturer support will still be around|
|RPM||5400 RPM||The higher the RPM, the faster the hard drive, and the faster stored data can be accessed|
|Drive Interface||SATA 3Gb/s||The interface is the type of motherboard connection and defines the bandwidth limit of the drive|
The Hitachi HTS545032B9A300 300GB is a hard disk drive, which means it stores data using quickly rotating disks, or platters, that can be read and written on via the moving actuator arm. Hard disk drives generally have a large storage capacity, and so are perfect for large amounts of data. The potential performance is well below that of solid-state drives, but they can definitely still hold their own. The Hitachi HTS545032B9A300 300GB is a fairly poor primary hard disk drive choice, as its performance leaves a lot to be desired. It would be fine to use as basic data storage, though.
At a speed of 5400 RPM, the hard disk drive spins at a below average speed. This speed is common for laptop hard drives, and may have long-term reliability and low-power benefits, but the resulting hard drive performance is noticeably slow.
With a capacity of 300GB, the Hitachi HTS545032B9A300 300GB has a very small amount of storage space for an hard disk driveUsing the SATA 2.0 3Gb/s interface this hard disk drive will not be limited by its connection with the motherboard, and there is currently no real reason to choose SATA 3.0 over SATA 2.0 for a mechanical hard disk drive (SSDs are another matter).
A form factor size of 2.5" is standard for laptop drives and solid-state drives, and this will fit into any 2.5" drive bay. These drive bays are not yet ubiquitous, but it will also fit into a standard 3.5" or 5.25" drive bay with the appropriate adapter.