The Seagate ST3250310SV 250GB is a 3.5" 250GB Hard Disk Drive.
It uses the SATA 3Gb/s interface.
|Drive Type||Hard Disk Drive||This defines whether the drive is a large-capacity slower hard disk drive, a smaller-capacity but much faster solid-state drive, or a hybrid|
|Physical Size||3.5"||The size of the drive dictates which drive bays it will fit into - generally a small drive will fit into any bigger drive bay with an adapter|
|Capacity||250GB||The drive storage capacity is the limit to the size of files that can be stored|
|Cache Size||8MB||The bigger the cache, the more data that can be temporarily stored for faster access|
|Power Required||5W||HDDs should generally require very little power to run, and SSDs even less|
|Drive Interface||SATA 3Gb/s||The interface is the type of motherboard connection and defines the bandwidth limit of the drive|
The Seagate ST3250310SV 250GB is a hard disk drive, which means it stores data using quickly rotating disks, or platters, that can be read and written on via the moving actuator arm. Hard disk drives generally have a large storage capacity, and so are perfect for large amounts of data. The potential performance is well below that of solid-state drives, but they can definitely still hold their own. The Seagate ST3250310SV 250GB is a fairly poor primary hard disk drive choice, as its performance leaves a lot to be desired. It would be fine to use as basic data storage, though.
With a cache of 8MB, the Seagate ST3250310SV 250GB can store a very small amount of data temporarily. Loading data that has previously been loaded will result in barely any difference in access speed and load duration. At a speed of 0 RPM, the hard disk drive spins at a very slow speed. This speed should be avoided entirely unless used as a dedicated storage system, as the resulting performance would be infuriatingly slow.
With a capacity of 250GB, the Seagate ST3250310SV 250GB has a very small amount of storage space for an hard disk driveUsing the SATA 2.0 3Gb/s interface this hard disk drive will not be limited by its connection with the motherboard, and there is currently no real reason to choose SATA 3.0 over SATA 2.0 for a mechanical hard disk drive (SSDs are another matter).
A form factor size of 3.5" is standard for desktop drives, and this will fit into any standard case drive bay, or into a 5.25" drive bay with an adapter.