The Seagate ST31000528ASQ 1TB is a 3.5" 1000GB Hard Disk Drive.
It uses the SATA 6Gb/s interface and has a speed of 7200 RPM.
|Drive Type||Hard Disk Drive||This defines whether the drive is a large-capacity slower hard disk drive, a smaller-capacity but much faster solid-state drive, or a hybrid|
|Physical Size||3.5"||The size of the drive dictates which drive bays it will fit into - generally a small drive will fit into any bigger drive bay with an adapter|
|Capacity||1000GB||The drive storage capacity is the limit to the size of files that can be stored|
|Cache Size||32MB||The bigger the cache, the more data that can be temporarily stored for faster access|
|RPM||7200 RPM||The higher the RPM, the faster the hard drive, and the faster stored data can be accessed|
|Drive Interface||SATA 6Gb/s||The interface is the type of motherboard connection and defines the bandwidth limit of the drive|
The Seagate ST31000528ASQ 1TB is a hard disk drive, which means it stores data using quickly rotating disks, or platters, that can be read and written on via the moving actuator arm. Hard disk drives generally have a large storage capacity, and so are perfect for large amounts of data. The potential performance is well below that of solid-state drives, but they can definitely still hold their own. The Seagate ST31000528ASQ 1TB is a fairly poor primary hard disk drive choice, as its performance leaves a lot to be desired. It would be fine to use as basic data storage, though.
With a cache of 32MB, the Seagate ST31000528ASQ 1TB can store a large amount of data temporarily, which will result in speedy loading times for previously loaded files and applications. At a speed of 7200 RPM, the hard disk drive spins at about the market average for desktop PCs. This speed is widely considered the desktop standard, providing a good balance between reliability, cost, performance, and noise.
With a capacity of 1000GB, the Seagate ST31000528ASQ 1TB has a decent amount of storage. Using the SATA 3.0 6Gb/s interface this hard disk drive will never be limited by its connection with the motherboard. In fact, mechanical hard disk drives cannot even reach the bandwidth capacity allowed by SATA 2.0 3Gb/s, so it would not matter even if it were plugged into a SATA 2.0 motherboard slot.
A form factor size of 3.5" is standard for desktop drives, and this will fit into any standard case drive bay, or into a 5.25" drive bay with an adapter.