The SilverStone Strider ST56F 560W has a maximum capacity of 560 Watts.
It has an 80 Plus rating of Not sure, is built to be silent, and its dimensions (LxWxH) are 14cm x 15cm x 8.6cm.
|Form Factor||ATX12V & EPS12V||Height||8.6cm|
|80 Plus Rating||Not sure||Fan Size||120mm|
|Input Voltage||100V - 240V||Modular||no|
|Input Frequency Range||50Hz - 60Hz||Silent||yes|
|+3.3V Output||30A||24 Pin Mobo Connector||yes|
|+5V Output||30A||4+4 Pin CPU Connector||yes|
|+12V Output||18A||6 Pin Connectors||2|
|+12V Count||2||4 Pin Connectors||6|
The SilverStone Strider ST56F 560W power supply has a maximum wattage output of 560W. This is a mid-range capacity, and should be fine as long as it is part of an equally mid-range system build. Always make sure that a purchased PSU is capable of powering your system. Remember that a higher PSU capacity does not necessarily equate to a higher wattage output and a more expensive electricity bill. In fact, you may find that a higher capacity PSU will function more efficiently than a lower capacity PSU because it is dealing with a lower percentage of its maximum load - that is, it is not being stressed to the same extent.
The SilverStone Strider ST56F 560W has an 80 Plus rating of Not sure. This means the PSU operates at average efficiency levels of at least
The dimensions of the SilverStone Strider ST56F 560W (LxWxH) are 14cm x 15cm x 8.6cm. Make sure to compare these measurements against the case you desire if planning on using it in a build.
The SilverStone Strider ST56F 560W is not modular, meaning that cables are built into the PSU itself and cannot be taken out and connected back in as necessary. This can result in difficult cable management and consequently a messy build and poor airflow.
The SilverStone Strider ST56F 560W is designed for low volumes, meaning that its constant drone while your PC is on would be less noticeable - ideal for those that prefer silent environments.