The SeaSonic SS-300TGW has a maximum capacity of 300 Watts.
It has an 80 Plus rating of Gold, is built to be silent, and its dimensions (LxWxH) are 6.9cm x 3.3cm x 2.5cm.
|Form Factor||Not sure||Length||6.9cm|
|80 Plus Rating||Gold||Width||3.3cm|
|Input Voltage||100V - 240V||Height||2.5cm|
|Input Frequency Range||50Hz - 60Hz||Modular||no|
|+5V Output||14A||24 Pin Mobo Connector||yes|
|+12V Output||25A||4+4 Pin CPU Connector||yes|
The SeaSonic SS-300TGW power supply has a maximum wattage output of 300W. This is a very low PSU capacity, and should only be used when powering a low power system. Remember that a higher PSU capacity does not necessarily equate to a higher wattage output and a more expensive electricity bill. In fact, you may find that a higher capacity PSU will function more efficiently than a lower capacity PSU because it is dealing with a lower percentage of its maximum load - that is, it is not being stressed to the same extent.
The SeaSonic SS-300TGW has an 80 Plus rating of Gold. This means the PSU operates at average efficiency levels of at least 87%, 90%, and 87% for loads of 100%, 50%, and 20% respectively. Gold is the second-best 80 Plus certificate available, and as such the SeaSonic SS-300TGW is extremely efficient and comes highly recommended.
The dimensions of the SeaSonic SS-300TGW (LxWxH) are 6.9cm x 3.3cm x 2.5cm. Make sure to compare these measurements against the case you desire if planning on using it in a build.
The SeaSonic SS-300TGW is not modular, meaning that cables are built into the PSU itself and cannot be taken out and connected back in as necessary. This can result in difficult cable management and consequently a messy build and poor airflow.
The SeaSonic SS-300TGW is designed for low volumes, meaning that its constant drone while your PC is on would be less noticeable - ideal for those that prefer silent environments.