The Kingwin ABT-750MM has a maximum capacity of 750 Watts.
It has an 80 Plus rating of Not sure, is built to be silent, and its dimensions (LxWxH) are 14.5cm x 15cm x 8.5cm.
|Form Factor||Not sure||Fan Size||120mm|
|80 Plus Rating||Not sure||Modular||no|
|Input Voltage||115V - 230V||Silent||yes|
|Input Frequency Range||50Hz - 60Hz||24 Pin Mobo Connector||yes|
|+3.3V Output||24A||4+4 Pin CPU Connector||yes|
|+5V Output||32A||8 Pin Connectors||1|
|+12V Output||55A||6 Pin Connectors||1|
|+12V Count||1||4 Pin Connectors||5|
The Kingwin ABT-750MM power supply has a maximum wattage output of 750W. This should run most PC builds with ease, but might not be enough for power hungry graphics card setups such as SLI or Crossfire combinations. Remember that a higher PSU capacity does not necessarily equate to a higher wattage output and a more expensive electricity bill. In fact, you may find that a higher capacity PSU will function more efficiently than a lower capacity PSU because it is dealing with a lower percentage of its maximum load - that is, it is not being stressed to the same extent.
The Kingwin ABT-750MM has an 80 Plus rating of Not sure. This means the PSU operates at average efficiency levels of at least
The dimensions of the Kingwin ABT-750MM (LxWxH) are 14.5cm x 15cm x 8.5cm. Make sure to compare these measurements against the case you desire if planning on using it in a build.
The Kingwin ABT-750MM is not modular, meaning that cables are built into the PSU itself and cannot be taken out and connected back in as necessary. This can result in difficult cable management and consequently a messy build and poor airflow.
The Kingwin ABT-750MM is designed for low volumes, meaning that its constant drone while your PC is on would be less noticeable - ideal for those that prefer silent environments.