The Compuware CPR-9011-6M1 900 watts has a maximum capacity of 900 Watts.
It has an 80 Plus rating of Titanium, is built to be modular, and its dimensions (LxWxH) are 185cm x 73cm x 40cm.
|Form Factor||Not sure||Width||73cm|
|80 Plus Rating||Titanium||Height||40cm|
|Input Voltage||100V - 240V||Silent||no|
|Input Frequency Range||47Hz - 63Hz||24 Pin Mobo Connector||yes|
|+12V Output||72A||4+4 Pin CPU Connector||yes|
The Compuware CPR-9011-6M1 900 watts power supply has a maximum wattage output of 900W. This should run most PC builds with ease, but might not be enough for power hungry graphics card setups such as SLI or Crossfire combinations. Remember that a higher PSU capacity does not necessarily equate to a higher wattage output and a more expensive electricity bill. In fact, you may find that a higher capacity PSU will function more efficiently than a lower capacity PSU because it is dealing with a lower percentage of its maximum load - that is, it is not being stressed to the same extent.
The Compuware CPR-9011-6M1 900 watts has an 80 Plus rating of Titanium. This means the PSU operates at average efficiency levels of at least
The dimensions of the Compuware CPR-9011-6M1 900 watts (LxWxH) are 185cm x 73cm x 40cm. Make sure to compare these measurements against the case you desire if planning on using it in a build.
The Compuware CPR-9011-6M1 900 watts is modular, meaning that cables can be taken out and connected back in as necessary. This can make cable management much easier, leading to a less chaotic build, and better airflow.
The Compuware CPR-9011-6M1 900 watts is not designed for low volumes, meaning that its constant drone while your PC is on could potentially be noticeable and irritating, though this may only be a problem for those that require silent environments.