The Apevia ATX-AP800W 800W has a maximum capacity of 800 Watts.
It has an 80 Plus rating of Not sure and its dimensions (LxWxH) are 6.1cm x 5.9cm x 3.4cm.
|80 Plus Rating||Not sure||Silent||no|
|Localization||United States||24 Pin Mobo Connector||yes|
|Input Voltage||115V - 230V||4+4 Pin CPU Connector||yes|
|Input Frequency Range||50Hz - 60Hz||8 Pin Connectors||1|
|Length||6.1cm||4 Pin Connectors||4|
The Apevia ATX-AP800W 800W power supply has a maximum wattage output of 800W. This should run most PC builds with ease, but might not be enough for power hungry graphics card setups such as SLI or Crossfire combinations. Remember that a higher PSU capacity does not necessarily equate to a higher wattage output and a more expensive electricity bill. In fact, you may find that a higher capacity PSU will function more efficiently than a lower capacity PSU because it is dealing with a lower percentage of its maximum load - that is, it is not being stressed to the same extent.
The Apevia ATX-AP800W 800W has an 80 Plus rating of Not sure. This means the PSU operates at average efficiency levels of at least
The dimensions of the Apevia ATX-AP800W 800W (LxWxH) are 6.1cm x 5.9cm x 3.4cm. Make sure to compare these measurements against the case you desire if planning on using it in a build.
The Apevia ATX-AP800W 800W is not modular, meaning that cables are built into the PSU itself and cannot be taken out and connected back in as necessary. This can result in difficult cable management and consequently a messy build and poor airflow.
The Apevia ATX-AP800W 800W is not designed for low volumes, meaning that its constant drone while your PC is on could potentially be noticeable and irritating, though this may only be a problem for those that require silent environments.