Loading build...
Loading...
Your Shops

Antec

Antec BP430 430W

The Antec BP430 430W has a maximum capacity of 430 Watts.

It has an 80 Plus rating of Standard and its dimensions (LxWxH) are 14cm x 15cm x 8.5cm.

7.2

Antec BP430 430W

help iconCapacity430Whelp iconLength14cm
help iconForm FactorATX12Vhelp iconWidth15cm
help icon80 Plus RatingStandardhelp iconHeight8.5cm
help iconEfficiency at 100%80.87%help iconFan Size80mm
help iconEfficiency at 50%85.95%help iconModularno
help iconEfficiency at 20%85.12%help iconSilentno
help iconInput Voltage100V - 240Vhelp icon24 Pin Mobo Connectoryes
help iconInput Frequency Range47Hz - 63Hzhelp icon4+4 Pin CPU Connectorno
help icon+3.3V Output20Ahelp icon6 Pin Connectors1
help icon+5V Output20Ahelp icon4 Pin Connectors1
help icon+12V Output17Ahelp iconSATA Connector3
help icon+12V Count2

Antec BP430 430W compatibility review

The Antec BP430 430W power supply has a maximum wattage output of 430W. This is a very low PSU capacity, and should only be used when powering a low power system. Remember that a higher PSU capacity does not necessarily equate to a higher wattage output and a more expensive electricity bill. In fact, you may find that a higher capacity PSU will function more efficiently than a lower capacity PSU because it is dealing with a lower percentage of its maximum load - that is, it is not being stressed to the same extent.

The Antec BP430 430W has an 80 Plus rating of Standard. This means the PSU operates at average efficiency levels of at least 80% for loads of 100%, 50%, and 20%. Standard is the lowest 80 Plus certificate available, but with 80% load efficiency minimums, the Antec BP430 430W is still reliably efficient and is by no means a bad PSU choice. The actual efficiencies for this PSU are 80.87%, 85.95%, and 85.12%, for loads of 100%, 50%, and 20%.

The dimensions of the Antec BP430 430W (LxWxH) are 14cm x 15cm x 8.5cm. Make sure to compare these measurements against the case you desire if planning on using it in a build.

The Antec BP430 430W is not modular, meaning that cables are built into the PSU itself and cannot be taken out and connected back in as necessary. This can result in difficult cable management and consequently a messy build and poor airflow.

The Antec BP430 430W is not designed for low volumes, meaning that its constant drone while your PC is on could potentially be noticeable and irritating, though this may only be a problem for those that require silent environments.

Merchant Comparison
Merchant Price
amazon $0.00
Custom PC Builder Auto PC Builder Compare PSU All Power Supply list
Best Compatible Hardware by Price
Type :
$ $

Similar PSUs to Antec BP430 430W