The Andyson Platinum 850W has a maximum capacity of 850 Watts.
It has an 80 Plus rating of Platinum, is built to be modular,, is built to be silent, and its dimensions (LxWxH) are 16.5cm x 15cm x 8.6cm.
|Form Factor||ATX12V & EPS12V||Width||15cm|
|80 Plus Rating||Platinum||Height||8.6cm|
|Input Voltage||110V - 264V||Modular||yes|
|Input Frequency Range||47Hz - 63Hz||Silent||yes|
|+3.3V Output||20A||24 Pin Mobo Connector||yes|
|+5V Output||20A||4+4 Pin CPU Connector||yes|
The Andyson Platinum 850W power supply has a maximum wattage output of 850W. This should run most PC builds with ease, but might not be enough for power hungry graphics card setups such as SLI or Crossfire combinations. Remember that a higher PSU capacity does not necessarily equate to a higher wattage output and a more expensive electricity bill. In fact, you may find that a higher capacity PSU will function more efficiently than a lower capacity PSU because it is dealing with a lower percentage of its maximum load - that is, it is not being stressed to the same extent.
The Andyson Platinum 850W has an 80 Plus rating of Platinum. This means the PSU operates at average efficiency levels of at least 89%, 92%, and 90% for loads of 100%, 50%, and 20% respectively. Platinum is the best 80 Plus certificate available, and as such the Andyson Platinum 850W is exceptionally efficient and comes very highly recommended.
The dimensions of the Andyson Platinum 850W (LxWxH) are 16.5cm x 15cm x 8.6cm. Make sure to compare these measurements against the case you desire if planning on using it in a build.
The Andyson Platinum 850W is modular, meaning that cables can be taken out and connected back in as necessary. This can make cable management much easier, leading to a less chaotic build, and better airflow.
The Andyson Platinum 850W is designed for low volumes, meaning that its constant drone while your PC is on would be less noticeable - ideal for those that prefer silent environments.