The AcBel PC6018 700W has a maximum capacity of 700 Watts.
It has an 80 Plus rating of Standard and its dimensions (LxWxH) are 15cm x 15cm x 8.6cm.
|80 Plus Rating||Standard||Width||15cm|
|Input Voltage||90V - 264V||Fan Size||120mm|
|Input Frequency Range||50Hz - 60Hz||Modular||no|
|+5V Output||25A||24 Pin Mobo Connector||yes|
|+12V Output||18A||4+4 Pin CPU Connector||yes|
The AcBel PC6018 700W power supply has a maximum wattage output of 700W. This should run most PC builds with ease, but might not be enough for power hungry graphics card setups such as SLI or Crossfire combinations. Remember that a higher PSU capacity does not necessarily equate to a higher wattage output and a more expensive electricity bill. In fact, you may find that a higher capacity PSU will function more efficiently than a lower capacity PSU because it is dealing with a lower percentage of its maximum load - that is, it is not being stressed to the same extent.
The AcBel PC6018 700W has an 80 Plus rating of Standard. This means the PSU operates at average efficiency levels of at least 80% for loads of 100%, 50%, and 20%. Standard is the lowest 80 Plus certificate available, but with 80% load efficiency minimums, the AcBel PC6018 700W is still reliably efficient and is by no means a bad PSU choice.
The dimensions of the AcBel PC6018 700W (LxWxH) are 15cm x 15cm x 8.6cm. Make sure to compare these measurements against the case you desire if planning on using it in a build.
The AcBel PC6018 700W is not modular, meaning that cables are built into the PSU itself and cannot be taken out and connected back in as necessary. This can result in difficult cable management and consequently a messy build and poor airflow.
The AcBel PC6018 700W is not designed for low volumes, meaning that its constant drone while your PC is on could potentially be noticeable and irritating, though this may only be a problem for those that require silent environments.