The Zalman Z9 DIII conforms to the ATX form factor and so can accommodate motherboards with form factors ATX and Micro-ATX.
It is made of Steel and its dimensions (LxWxH) are 504mm x 207mm x 460mm.
|Form Factor||ATX||Front Fans Size||140mm|
|Motherboard Form Factors||Top Fans||2|
|Material||Steel||Top Fans Size||140mm|
|Expansion Slots||7||Side Fans Size||120mm|
|5.25″ Drive Bays||3||Rear Fans||1|
|3.5″ Drive Bays||5||Rear Fans Size||120mm|
|2.5" Drive Bays||1||Bottom Fans||1|
|Tool-less Rails||no||Bottom Fans Size||140mm|
|Length||504mm||IO Display Panel||yes|
|Width||207mm||Front USB 2.0 Slots||4|
|Height||460mm||Front USB 3.0 Slots||1|
|Maximum Graphics Card Length||290mm||eSATA||no|
|Front Fans||1||Audio IO||yes|
The Zalman Z9 DIII has a the ATX form factor. ATX is the most ubiquitous of case standards, providing the largest array of compatible hardware on the market. Using the ATX standard, the case can house motherboards and power supplies with form factors ATX and Micro-ATX. The dimensions of the case itself (LxWxH) are 504mm x 207mm x 460mm.
The Zalman Z9 DIII has seven expansion slots, so there is plenty of room for extra components, which may be a deciding factor when planning on the longevity and build type of a PC system. The case has three 5.25" drive bays, which is enough to house an optical drive and a couple of hard drives, while still having space for plenty more HDDs with the five 3.5" drive bays that are also available. You can even install an SSD or laptop-sized HDD using the one 2.5" drive bay.
Made primarily of Steel, the Zalman Z9 DIII is built to be strong and well-ventilated. Steel cases are generally fairly cheap and sturdy, but also tend to be quite heavy. Whatever your case's material, it is important to keep a consistent airflow so that heat doesn't build up inside. It is therefore advised that you make use of the available built-in case fans and fan installation sections.