The Intex Sigma conforms to the ATX form factor and so can accommodate motherboards with form factors ATX and Micro-ATX.
It is made of Steel and its dimensions (LxWxH) are 450mm x 217mm x 430mm.
|Motherboard Form Factors||Side Fans||1|
|Material||Steel||Side Fans Size||120mm|
|Expansion Slots||7||Rear Fans Size||80mm|
|5.25″ Drive Bays||4||IO Display Panel||yes|
|3.5″ Drive Bays||3||Front USB 2.0 Slots||2|
|2.5" Drive Bays||0||Front USB 3.0 Slots||0|
The Intex Sigma has a the ATX form factor. ATX is the most ubiquitous of case standards, providing the largest array of compatible hardware on the market. Using the ATX standard, the case can house motherboards and power supplies with form factors ATX and Micro-ATX. The dimensions of the case itself (LxWxH) are 450mm x 217mm x 430mm.
The Intex Sigma has seven expansion slots, so there is plenty of room for extra components, which may be a deciding factor when planning on the longevity and build type of a PC system. The case has four 5.25" drive bays, which is enough to house an optical drive and a couple of hard drives, while still having a couple of extra free hard drives with the three 3.5" drive bays that are also available. To mount an SSD you would require an adapter, however, as there are no 2.5" drive bays. Installation of hard drives into these drive bays is made all the more easier by screwless rails that allow tool-less mounting.
Made primarily of Steel, the Intex Sigma is built to be strong and well-ventilated. Steel cases are generally fairly cheap and sturdy, but also tend to be quite heavy. Whatever your case's material, it is important to keep a consistent airflow so that heat doesn't build up inside. It is therefore advised that you make use of the available built-in case fans and fan installation sections.