The Intex Shield conforms to the ATX form factor and so can accommodate motherboards with form factors ATX and Micro-ATX.
It is made of Steel and its dimensions (LxWxH) are 365mm x 178mm x 350mm.
|Motherboard Form Factors||Side Fans||1|
|Material||Steel||Side Fans Size||80mm|
|Expansion Slots||4||Rear Fans Size||80mm|
|5.25″ Drive Bays||2||IO Display Panel||yes|
|3.5″ Drive Bays||0||Front USB 2.0 Slots||1|
|2.5" Drive Bays||0||Front USB 3.0 Slots||0|
The Intex Shield has a the ATX form factor. ATX is the most ubiquitous of case standards, providing the largest array of compatible hardware on the market. Using the ATX standard, the case can house motherboards and power supplies with form factors ATX and Micro-ATX. The dimensions of the case itself (LxWxH) are 365mm x 178mm x 350mm.
The Intex Shield has four expansion slots, so there is some room for extra components, which may be a deciding factor when planning on the longevity and build type of a PC system. The case has two 5.25" drive bays, which There are no 5.25" drive bays, and no recorded 3.5" drive bays. This may be a data discrepancy, but otherwise we would highly recommend you look elsewhere for a case. Installation of hard drives into these drive bays is made all the more easier by screwless rails that allow tool-less mounting.
Made primarily of Steel, the Intex Shield is built to be strong and well-ventilated. Steel cases are generally fairly cheap and sturdy, but also tend to be quite heavy. Whatever your case's material, it is important to keep a consistent airflow so that heat doesn't build up inside. It is therefore advised that you make use of the available built-in case fans and fan installation sections.