The Emaxx Rebel conforms to the Micro-ATX form factor and so can accommodate motherboards with form factors ATX and Micro-ATX.
|Form Factor||Micro-ATX||Front Fans Size||120mm|
|Motherboard Form Factors||Rear Fans||1|
|Material||Steel||Rear Fans Size||90mm|
|5.25″ Drive Bays||1||Bottom Fans Size||120mm|
|3.5″ Drive Bays||4||IO Display Panel||yes|
|2.5" Drive Bays||0||Front USB 2.0 Slots||4|
|Tool-less Rails||yes||Front USB 3.0 Slots||0|
|Maximum Graphics Card Length||250mm||eSATA||no|
|Front Fans||2||Audio IO||yes|
The Emaxx Rebel has a the Micro-ATX form factor. Micro-ATX is a smaller version of the ATX standard which is designed to make your case and the system therein lightweight and portable. Using the Micro-ATX standard, the case can house motherboards and power supplies with form factors ATX and Micro-ATX.
The case has one 5.25" drive bays, which is enough room for an optical drive but little else, and with just one 3.5" drive bay, there is basically no room at all for expansion. There is also no 2.5" drive bay for a laptop-sized HDD or solid-state drive. Installation of hard drives into these drive bays is made all the more easier by screwless rails that allow tool-less mounting.
Made primarily of Steel, the Emaxx Rebel is built to be strong and well-ventilated. Steel cases are generally fairly cheap and sturdy, but also tend to be quite heavy. Whatever your case's material, it is important to keep a consistent airflow so that heat doesn't build up inside. It is therefore advised that you make use of the available built-in case fans and fan installation sections.