The Dazumba DVito 782 conforms to the ATX form factor and so can accommodate motherboards with form factors ATX and Micro-ATX.
It is made of Steel and its dimensions (LxWxH) are 430mm x 185mm x 420mm.
|Form Factor||ATX||Maximum Graphics Card Length||280mm|
|Motherboard Form Factors||Front Fans||1|
|Material||Steel||Front Fans Size||120mm|
|Expansion Slots||7||Side Fans Size||120mm|
|5.25″ Drive Bays||3||Rear Fans||1|
|3.5″ Drive Bays||4||Rear Fans Size||120mm|
|2.5" Drive Bays||0||IO Display Panel||yes|
|Tool-less Rails||no||Front USB 2.0 Slots||0|
|Length||430mm||Front USB 3.0 Slots||1|
The Dazumba DVito 782 has a the ATX form factor. ATX is the most ubiquitous of case standards, providing the largest array of compatible hardware on the market. Using the ATX standard, the case can house motherboards and power supplies with form factors ATX and Micro-ATX. The dimensions of the case itself (LxWxH) are 430mm x 185mm x 420mm.
The Dazumba DVito 782 has seven expansion slots, so there is plenty of room for extra components, which may be a deciding factor when planning on the longevity and build type of a PC system. The case has three 5.25" drive bays, which is enough to house an optical drive and a couple of hard drives, while still having a couple of extra free hard drives with the four 3.5" drive bays that are also available. To mount an SSD you would require an adapter, however, as there are no 2.5" drive bays.
Made primarily of Steel, the Dazumba DVito 782 is built to be strong and well-ventilated. Steel cases are generally fairly cheap and sturdy, but also tend to be quite heavy. Whatever your case's material, it is important to keep a consistent airflow so that heat doesn't build up inside. It is therefore advised that you make use of the available built-in case fans and fan installation sections.