The DIYPC Zondda-O conforms to the ATX form factor and so can accommodate motherboards with form factors ATX and Micro-ATX.
It is made of Steel and its dimensions (LxWxH) are 432mm x 204mm x 473mm.
|Form Factor||ATX||Maximum CPU Cooler Size||150mm|
|Motherboard Form Factors||Front Fans||1|
|Material||Metal||Front Fans Size||120mm|
|Expansion Slots||7||Side Fans Size||120mm|
|5.25″ Drive Bays||1||Rear Fans||1|
|3.5″ Drive Bays||4||Rear Fans Size||120mm|
|2.5" Drive Bays||2||IO Display Panel||no|
|Tool-less Rails||no||Front USB 2.0 Slots||2|
|Length||432mm||Front USB 3.0 Slots||1|
|Maximum Graphics Card Length||420mm|
The DIYPC Zondda-O has a the ATX form factor. ATX is the most ubiquitous of case standards, providing the largest array of compatible hardware on the market. Using the ATX standard, the case can house motherboards and power supplies with form factors ATX and Micro-ATX. The dimensions of the case itself (LxWxH) are 432mm x 204mm x 473mm.
The DIYPC Zondda-O has seven expansion slots, so there is plenty of room for extra components, which may be a deciding factor when planning on the longevity and build type of a PC system. The case has one 5.25" drive bays, which is enough room for an optical drive but little else, and with just one 3.5" drive bay, there is basically no room at all for expansion. With two 2.5" bays, however, there is enough room for a laptop-sized HDD or solid-state drive.
Made primarily of Steel, the DIYPC Zondda-O is built to be strong and well-ventilated. Steel cases are generally fairly cheap and sturdy, but also tend to be quite heavy. Whatever your case's material, it is important to keep a consistent airflow so that heat doesn't build up inside. It is therefore advised that you make use of the available built-in case fans and fan installation sections.