7.1
The DIYPC Solo-T1-BK conforms to the ATX form factor and so can accommodate motherboards with form factors ATX and Micro-ATX.
It is made of Steel and its dimensions (LxWxH) are 437mm x 208mm x 430mm.
 | Form Factor | ATX | | Maximum Graphics Card Length | 375mm | ||
|---|---|---|---|---|---|---|---|
| Motherboard Form Factors |
| | Maximum CPU Cooler Size | 160mm | ||
| Material | Steel | | Front Fans | 1 | ||
| Color | Black | | Front Fans Size | 120mm | ||
| Expansion Slots | 7 | | Rear Fans | 1 | ||
| 5.25″ Drive Bays | 2 | | Rear Fans Size | 120mm | ||
| 3.5″ Drive Bays | 3 | | IO Display Panel | yes | ||
| 2.5" Drive Bays | 3 | | Front USB 2.0 Slots | 2 | ||
| Tool-less Rails | no | | Front USB 3.0 Slots | 1 | ||
| Length | 437mm | | eSATA | no | ||
| Width | 208mm | | Audio IO | yes | ||
| Height | 430mm |
The DIYPC Solo-T1-BK has a the ATX form factor. ATX is the most ubiquitous of case standards, providing the largest array of compatible hardware on the market. Using the ATX standard, the case can house motherboards and power supplies with form factors ATX and Micro-ATX. The dimensions of the case itself (LxWxH) are 437mm x 208mm x 430mm.
The DIYPC Solo-T1-BK has seven expansion slots, so there is plenty of room for extra components, which may be a deciding factor when planning on the longevity and build type of a PC system. The case has two 5.25" drive bays, which There are no 5.25" drive bays, but there are three 3.5" drive bays, which is quite a small amount of space, although you can install an SSD or laptop hard drive in one of the three 2.5" drive bays.
Made primarily of Steel, the DIYPC Solo-T1-BK is built to be strong and well-ventilated. Steel cases are generally fairly cheap and sturdy, but also tend to be quite heavy. Whatever your case's material, it is important to keep a consistent airflow so that heat doesn't build up inside. It is therefore advised that you make use of the available built-in case fans and fan installation sections.
