The Cubitek Tattoo Red conforms to the ATX form factor and so can accommodate motherboards with form factors ATX, Micro-ATX and Mini-ITX.
It is made of Steel and its dimensions (LxWxH) are 490mm x 200mm x 480mm.
|Form Factor||ATX||Maximum CPU Cooler Size||160mm|
|Motherboard Form Factors||Front Fans||1|
|Material||Steel||Front Fans Size||140mm|
|5.25″ Drive Bays||5||Top Fans Size||140mm|
|3.5″ Drive Bays||5||Rear Fans||1|
|2.5" Drive Bays||2||Rear Fans Size||120mm|
|Tool-less Rails||no||IO Display Panel||yes|
|Length||490mm||Front USB 2.0 Slots||0|
|Width||200mm||Front USB 3.0 Slots||2|
|Maximum Graphics Card Length||290mm||Audio IO||yes|
The Cubitek Tattoo Red has a the ATX form factor. ATX is the most ubiquitous of case standards, providing the largest array of compatible hardware on the market. Using the ATX standard, the case can house motherboards and power supplies with form factors ATX, Micro-ATX and Mini-ITX. The dimensions of the case itself (LxWxH) are 490mm x 200mm x 480mm.
The case has five 5.25" drive bays, which is more than enough to house various drives, particularly optical drives. With five 3.5" drive bays there is also plenty of extra HDD space as well. You can even slot in an SSD or a laptop drive in one of the two specifically designed 2.5" drive bays
Made primarily of Steel, the Cubitek Tattoo Red is built to be strong and well-ventilated. Steel cases are generally fairly cheap and sturdy, but also tend to be quite heavy. Whatever your case's material, it is important to keep a consistent airflow so that heat doesn't build up inside. It is therefore advised that you make use of the available built-in case fans and fan installation sections.