The Cooler Master: MasterCase Maker 5 conforms to the ATX form factor and so can accommodate motherboards with form factors ATX, Micro-ATX and Mini-ITX.
It is made of Steel and its dimensions (LxWxH) are 548mm x 235mm x 512mm.
|Release Date||10 May 2016||Maximum CPU Cooler Size||190mm|
|Form Factor||ATX||Front Fans||2|
|Motherboard Form Factors||Front Fans Size||140mm|
|Material||Steel||Front Fans Speed||1800 RPM|
|Expansion Slots||2||Rear Fans Size||140mm|
|5.25″ Drive Bays||2||Rear Fans Speed||1800 RPM|
|3.5″ Drive Bays||5||Case Fan dBA||999 dBA|
|2.5" Drive Bays||7||IO Display Panel||yes|
|Tool-less Rails||yes||Front USB 2.0 Slots||2|
|Length||548mm||Front USB 3.0 Slots||2|
|Maximum Graphics Card Length||412mm|
The Cooler Master: MasterCase Maker 5 has a the ATX form factor. ATX is the most ubiquitous of case standards, providing the largest array of compatible hardware on the market. Using the ATX standard, the case can house motherboards and power supplies with form factors ATX, Micro-ATX and Mini-ITX. The dimensions of the case itself (LxWxH) are 548mm x 235mm x 512mm.
The Cooler Master: MasterCase Maker 5 has two expansion slots, so there is very little room for extra components, which may be a deciding factor when planning on the longevity and build type of a PC system. The case has two 5.25" drive bays, which There are no 5.25" drive bays, but there are five 3.5" drive bays, which is more than enough space as long as you do not intend on installing an optical drive. Installation of hard drives into these drive bays is made all the more easier by screwless rails that allow tool-less mounting.
Made primarily of Steel, the Cooler Master: MasterCase Maker 5 is built to be strong and well-ventilated. Steel cases are generally fairly cheap and sturdy, but also tend to be quite heavy. Whatever your case's material, it is important to keep a consistent airflow so that heat doesn't build up inside. It is therefore advised that you make use of the available built-in case fans and fan installation sections.