The Azzatek Inferno 310 conforms to the ATX form factor and so can accommodate motherboards with form factors ATX, Micro-ATX and Mini-ITX.
It is made of Plastic and its dimensions (LxWxH) are 475mm x 205mm x 480mm.
|Form Factor||ATX||Maximum CPU Cooler Size||155mm|
|Motherboard Form Factors||Front Fans||2|
|Material||Plastic||Front Fans Size||140mm|
|Expansion Slots||7||Top Fans Size||120mm|
|5.25″ Drive Bays||1||Rear Fans||1|
|3.5″ Drive Bays||2||Rear Fans Size||120mm|
|2.5" Drive Bays||6||IO Display Panel||yes|
|Tool-less Rails||no||Front USB 2.0 Slots||0|
|Length||475mm||Front USB 3.0 Slots||2|
|Maximum Graphics Card Length||380mm|
The Azzatek Inferno 310 has a the ATX form factor. ATX is the most ubiquitous of case standards, providing the largest array of compatible hardware on the market. Using the ATX standard, the case can house motherboards and power supplies with form factors ATX, Micro-ATX and Mini-ITX. The dimensions of the case itself (LxWxH) are 475mm x 205mm x 480mm.
The Azzatek Inferno 310 has seven expansion slots, so there is plenty of room for extra components, which may be a deciding factor when planning on the longevity and build type of a PC system. The case has one 5.25" drive bays, which is enough room for an optical drive but little else, and with just one 3.5" drive bay, there is basically no room at all for expansion. With six 2.5" bays, however, there is enough room for a laptop-sized HDD or solid-state drive.
Made primarily of Plastic, the Azzatek Inferno 310 is built to be lightweight, but strong enough to keep your components protected. Plastic cases generally have a thin metal layer to improve protection, and are also generally fairily cheap. Whatever your case's material, it is important to keep a consistent airflow so that heat doesn't build up inside. It is therefore advised that you make use of the available built-in case fans and fan installation sections.