The Aerocool Xpredator X3 Devil Red conforms to the ATX form factor and so can accommodate motherboards with form factors ATX, Micro-ATX and Mini-ITX.
It is made of Steel and its dimensions (LxWxH) are 533mm x 233mm x 527mm.
|Form Factor||ATX||Front Fans Size||200mm|
|Motherboard Form Factors||Front Fans Speed||700 RPM|
|Expansion Slots||8||Rear Fans||1|
|5.25″ Drive Bays||3||Rear Fans Speed||1200 RPM|
|3.5″ Drive Bays||9||HDD Fans||2|
|2.5" Drive Bays||1||HDD Fans Size||120mm|
|Tool-less Rails||no||Bottom Fans Size||140mm|
|Length||533mm||IO Display Panel||yes|
|Width||233mm||Front USB 2.0 Slots||0|
|Height||527mm||Front USB 3.0 Slots||2|
|Maximum Graphics Card Length||310mm||eSATA||no|
|Maximum CPU Cooler Size||186mm||Audio IO||yes|
The Aerocool Xpredator X3 Devil Red has a the ATX form factor. ATX is the most ubiquitous of case standards, providing the largest array of compatible hardware on the market. Using the ATX standard, the case can house motherboards and power supplies with form factors ATX, Micro-ATX and Mini-ITX. The dimensions of the case itself (LxWxH) are 533mm x 233mm x 527mm.
The Aerocool Xpredator X3 Devil Red has eight expansion slots, so there is plenty of room for extra components, which may be a deciding factor when planning on the longevity and build type of a PC system. The case has three 5.25" drive bays, which is enough to house an optical drive and a couple of hard drives, while still having space for plenty more HDDs with the nine 3.5" drive bays that are also available. You can even install an SSD or laptop-sized HDD using the one 2.5" drive bay.
Made primarily of Steel, the Aerocool Xpredator X3 Devil Red is built to be strong and well-ventilated. Steel cases are generally fairly cheap and sturdy, but also tend to be quite heavy. Whatever your case's material, it is important to keep a consistent airflow so that heat doesn't build up inside. It is therefore advised that you make use of the available built-in case fans and fan installation sections.