The Aerocool AeroEngine Plus conforms to the ATX form factor and so can accommodate motherboards with form factors ATX and Micro-ATX.
It is made of Steel and its dimensions (LxWxH) are 440mm x 200mm x 430mm.
|Form Factor||ATX||Front Fans Size||140mm|
|Motherboard Form Factors||Front Fans Speed||1200 RPM|
|Color||Black||Side Fans Size||180mm|
|Expansion Slots||7||Side Fans Speed||800 RPM|
|5.25″ Drive Bays||9||Rear Fans||1|
|3.5″ Drive Bays||1||Rear Fans Size||120mm|
|2.5" Drive Bays||0||Case Fan dBA||64 dBA|
|Tool-less Rails||yes||IO Display Panel||yes|
|Length||440mm||Front USB 2.0 Slots||2|
|Width||200mm||Front USB 3.0 Slots||0|
|Front Fans||1||Audio IO||yes|
The Aerocool AeroEngine Plus has a the ATX form factor. ATX is the most ubiquitous of case standards, providing the largest array of compatible hardware on the market. Using the ATX standard, the case can house motherboards and power supplies with form factors ATX and Micro-ATX. The dimensions of the case itself (LxWxH) are 440mm x 200mm x 430mm.
The Aerocool AeroEngine Plus has seven expansion slots, so there is plenty of room for extra components, which may be a deciding factor when planning on the longevity and build type of a PC system. The case has nine 5.25" drive bays, which is more than enough to house various drives, particularly optical drives. There is only one 3.5" drive bay, though, so the large number of 5.25" drive bays is a necessity, particularly since there are also no 2.5" drive bays for an SSD or laptop-sized HDD. Installation of hard drives into these drive bays is made all the more easier by screwless rails that allow tool-less mounting.
Made primarily of Steel, the Aerocool AeroEngine Plus is built to be strong and well-ventilated. Steel cases are generally fairly cheap and sturdy, but also tend to be quite heavy. Whatever your case's material, it is important to keep a consistent airflow so that heat doesn't build up inside. It is therefore advised that you make use of the available built-in case fans and fan installation sections.